Allflex AFX-100 Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 53
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Rev Australasia V2.3 12/04
12 12
lifting one side away from the steel pipes, the current and read distance will be excellent.
Verify that sufficient read range performance is possible.
Note the screw driver blade sitting between the panel and the steel.
The good read distance shown above has been achieved by lifting one edge off the steel.
If you do temporarily position the reader like this, you can then mount the panel reader on
ply in the desired position. You can adjust the current up to around one amp, which
should give you great reading results, by either packing the antenna off the steel a little
(using spacers), lifting one edge away from the steel (as shown above), or by adjusting the
tune.
Tuning is a process that will adjust the antenna to perform in an area where an amount of
conductive metal is in close proximity. This is discussed in detail later, however, if you
require assistance, please call Allflex for telephone support. Allflex Australia 07 3245
9100. Allflex New Zealand - 06 356-7199.
In some cases, it is more practical to mount the antenna on a non-metallic material such
as timber and simply fit this into the crush (as shown below). This allows easy,
installation and removal where the antenna is moved often and also provides excellent
read distance.
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 52 53

Commentaires sur ces manuels

Pas de commentaire