Allflex Offices The Allflex RS320 Stick Reader User Manual Version 11 – March 2007 Allflex Europe (UK) Ltd. Unit
AC Adapter - The RS320 Stick Reader can be powered using its AC Adapter/Charger regardless of the charge state of the Battery Pa
AK320 Battery pack fast charger The AK320 fast charger is used to charge up to 3 PW320 Battery Packs simultaneously in 2 hours.
Activating the Stick Reader With the Battery Pack fully charged and installed, or with the AC Adapter connected by means of the Data/Power
NOTES: Display formats for other tag formats (other than ISO HDX tags) that can be read by the RS32
Reading eartags When a tag is successfully read, the tag's ID code information appears on the LCD readout. For “non-duplicate” tag re
4. RS320 BT (With Hardware ON / OFF switch) to a Bluetooth enabled PDA (Palm Top Computer / Portable Data Assistant) To Be Advised. Unde
Read Range Performance Figure 2 illustrates the read zone of the Stick Reader, within which tags can be successfully detected and read.
2. RS320BT to a Bluetooth adapter connected to a Computer Serial Port. Under this scenario, a Bluetooth adapter is used in the same manne
Discharged battery pack - As the battery pack discharges, the power available to activate the field becomes weaker and this reduc
Select the OPERATIONAL Tab (if it is hidden on your screen, click on the left arrow button which is to the right of the word “Wireless”
Allflex EID Readers with Dynamic Tuning NetworkTM Congratulations for your acquisition of an Allflex EID reader. This device is equipped
Figure 3 - Stick Reader Power Jack and Data Connector Wiring Diagram Serial output data appears on the Stick Reader‟s TxD/pin 2 co
Bluetooth – Known Successful Methods There are 4 scenarios to correctly implement Bluetooth. These are:- 1. RS320+CM301 to a Bluetooth
For HDX Industrial coded tags, the output format is: LR_0006_0000000018514348{CR}{LF} In this tag format, the prefix “LR” represents “lin
SPECIFICATIONS GENERAL INFORMATION RFID compatibility: ISO 11784 & 11785 HDX and FDX-B Description: Portable handheld fibreglass tube
Stick Reader User Interface Figure 1 illustrates the Stick Reader‟s features that comprise the user interface and that are
If you wish to disconnect or re-connect at any time you can use the two buttons in the top left corner of your HyperTerminal Window. St
Preparing for use In order to proceed, it is necessary first to fully charge the Battery Pack as described below and to have an few
HyperTerminal® comes standard with most windows installation. It can also be downloaded for free from http://www.hilgraeve.com/htpe
Step 3: Activating the RS320 Stick Reader and read test Press the Green Button to “Wake Up” the reader from Sleep Mode.
Serial Command Language This section is designed for the use of programmers and advanced users. The instructions listed in table 4, descri
Commentaires sur ces manuels